It’s definitely bent, lower bar is bent just above the crank, also the two thinner tubes above the lower bar should be welded to the tube holding the saddle but are now almost touching the rear wheel. If you’d sit on this, chances are it’ll break in half.
The two thinner tubes should be connected to the rear dropouts as a third set of stays. (Classic mixte frame) These dropouts look to be from a different bike, so someone just chopped them off.
It’s definitely bent, lower bar is bent just above the crank, also the two thinner tubes above the lower bar should be welded to the tube holding the saddle but are now almost touching the rear wheel. If you’d sit on this, chances are it’ll break in half.
I guess it’s art now
The two thinner tubes should be connected to the rear dropouts as a third set of stays. (Classic mixte frame) These dropouts look to be from a different bike, so someone just chopped them off.